50l High Pressure Heat Exchanger

Liquid Accumulator High Pressure Heat Exchanger Vertical / Horizontal Type

Liquid Accumulator Vertical / Horizontal Type For

Tube Heat Exchanger

The accumulator is a pressure vessel that is normally installed on a high pressure fluid pipe of a

refrigeration system to store the excess refrigerant caused by changes in the load of the refrigeration

system.

In some of the information also mentioned that there are low-pressure reservoir, but rare, it may be gas-

liquid separator can also bear some of the reasons for the function of liquid storage it In large systems, all

or part of the refrigerant in the refrigeration system can also be temporarily stored during maintenance or

repair to avoid waste. In the water-cooled condenser, it has a certain space at the bottom and also stores

the refrigerant liquid. In fact, in the fin tube, if there is no place to store the refrigerant liquid, then at the

bottom of it will accumulate liquid, thereby reducing the heat transfer area, affecting the condensation

effect, in which case it is best to add a reservoir.

In the air-cooled system, the reservoir can ensure that the liquid pipe is filled with refrigerant, thus

avoiding the thermal expansion valve due to the refrigerant liquid is not continuous and malfunction. And

the use of the reservoir can also increase the degree of subcooling to improve system efficiency. Mainly

divided into vertical and horizontal two.