R22 Flooded Heat Exchanger

R22 Refrigerating Unit Flooded Heat Exchanger Evaporator / Condenser Stainless Steel Tube

Full Liquid Type Refrigerating Unit Tube Heat Exchanger

Evaporator/Condenser

In the design, the shell is made of GB151 or TEMA-defined X-type structure (the tube bundle is supported

by a small number of supporting plates). The refrigerant inlet is equipped with a meaning liquid plate,

which is used to distribute the refrigerant passing the tube bundle evenly.

A certain amount of boiling space and gas-liquid separation of space, for some large full-liquid evaporator

in order to reduce the barrel diameter, leaving only a small amount of boiling space, while the upper part

of the evaporator is equipped with a gas-liquid separator (for the same reason), for R22 , R134a and

other HCFC refrigerants, in order to save copper, strengthen the tube heat transfer effect, often using

external enhanced efficient heat transfer tube.

With the development of efficient heat transfer technology, in the large air conditioning units, the heat

transfer coefficient outside the tube has been higher than the tube heat transfer coefficient, so the tube

has done a corresponding strengthening.

The type of refrigerant used and the heat transfer tube material and pipe and tube plate with the type of

dry.

Full-liquid evaporator is generally used in the refrigerant viscosity is small, that is, under the conditions of

use is very good mobility of the occasion.

FULL LIQUID TYPE EVAPORATOR AND CONDENSER EXTERNAL OIL

(SINGLE CIRCUIT) CAPACITY: 350KW TO 650KW

FULL LIQUID TYPE EVAPORATOR AND CONDENSER EXTERNAL OIL

(SINGLE CIRCUIT) CAPACITY: 700KW TO 1800KW

FULL LIQUID TYPE EVAPORATOR AND CONDENSER EXTERNAL OIL

(DOUBLE CIRCUIT) CAPACITY: 800KW TO 2200KW

COOPERATED CLENTS